14
0
0 00
OK
Electronic programmer
– functions
OK
– function selection button
<
– “–” button
>
– “+” button
OPERATION
Setting the time
After connection to the mains or reconnection
after a power cut the display shows flash 0.00:
Timer
The timer can be activated at any time, re-
gardless of the status of other functions. The
timer can be set for from 1 minute to up to 23
hours and 59 minutes.
To set the timer you should:
Press button
OK
, then the display will show
flashing
,
0
0 00
OK
set the timer using buttons
>
and
<
.
The time set is shown on the display and the
signal function is on.
Press button
OK
,
<
or
>
in order to switch
off the signal, the signal function will go out
and the display will show the current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
Press and hold
OK
(or simultaneously
press
<
and
>
) until you will see on the
display and the dot below the symbol is
flashing,
Press
<
or
>
within 7 seconds to set the
current time.
To store the new time setting, wait approxi-
mately 7 seconds after time has been set.
The dot below the
symbol will stop flashing.
You can adjust the time later. To do this press
<
and
>,
simultaneously and adjust the cur-
rent time while the dot below the symbol
is flashing.