43
OPERATION IN CASE OF EMERGENCY
In the event of an emergency, you should:
switch off all working units of the cooker
disconnect the mains plug
call the service centre
some minor faults can be fixed by referring to the instructions given in the table below.
Before calling the customer support centre or the service centre check the following points
that are presented in the table.
PROBLEM
REASON
ACTION
1.The appliance does not work. break in power supply
check the household fuse box,
if there is a blown fuse replace
it with a new one
2.The programmer display
shows “0.00”.
the appliance was disconnec-
ted from the mains or there was
a temporary power cut.
Set the current time
(see ‘
Use of the programmer’
).
3. The oven lighting does not
work
the bulb is loose or damaged
tighten up or replace the blown
bulb (see Chapter
Cleaning and
Maintenance)
4.A single cooking zone switches
off and residual heat indicator „H”
is shown.
limited cook time
- switch on the cooking zone again
5. Residual heat indicator extin-
guished even though the cooking
zones are hot
a power outage or the applian-
ce has been disconnected
residual heat indicator will be
shown again the next time the
appliance is turned on and off
again
6. Induction hob makes buzzing
sound.
this is normal. Cooling fan is operating to cool down internal electronics.
7. Induction hob makes hissing
and whistling sounds
This is normal. When using several cooking zones at full power, the
hob makes hissing and whistling sounds due to the frequencies used
to power the coils
8. Hob cooking surface is crac-
ked.
Danger! Immediately unplug the appliance or switch off the main
circuit breaker. Refer the repair to the nearest service centre.
9.When the problem is still
not remedied.
Immediately unplug the appliance or switch off the main circuit
breaker (fuse). Refer the repair to the nearest service centre.
Important!
You are responsible for operating the appliance correctly and
maintaining its good condition. If you call service as a result of
operating the appliance incorrectly you will be responsible for
the costs incurred even under warranty.
The manufacturer shall not be held liable for damage caused
by failure to follow this manual.
10. E2 symbol displayed
Induction coil overheated
insufficient cooling, check if
cookware complies,
with requirements listed on
page 20/21.
Содержание 5022IE3.325eEHTbDHbScJQa
Страница 88: ......