amiad Filtomat MG-110P, Инструкции по установке, эксплуатации и обслуживанию

Страница: 32 / 51

MG110P
7.2013 Page 32 of 51
G. Monitoring
During the regular operation of the controller it is possible to:
Monitor the current status of the controller
Read information on past activities of the system
Perform manual operation and intervene in the flushing process
Read and monitor the voltage of the controllers battery
The layout of the screens involved in the controller’s Monitoring can be found on page 10 of this manual. The following
table describes each one of the controller’s Monitoring screens and it contains three columns.
The first column shows the screen number as appears at the upper left corner of the screen drawing in the
layout diagram on page 10 of this manual.
The second column shows the default setting of the screen.
The third column explains the controller-task controlled by this screen.
Number Screen Description
2
Status:B.Flushin
Time: 4:23:35
This screen shows the current status of the controller.
The upper line: - shows the current status, The possible messages are:
Flushing
(the flushing filter number is also displayed)
Between filters
(counting the delay between filters)
Between flushing cycles
(counting the time to the next flushing cycle)
Delay
(counting the D.P. delay)
Fault
(the controller is at D.P. fault)
The lower line: - shows the count down of the time related to the upper
line message, for example:
When the controller is between flushing cycles this line shows
the time left to the next flushing cycle.
When filter number 1 is flushing this line shows the time left for
this filter to flush.
3
For manual flush
Press <ENTER>
In this screen the user can manually start and stop a flushing cycle.
Press Enter to immediately initiate a flushing cycle. Once the
cycle is started the controller displays the status screen
( screen
number 2 ).
Press the right arrow key to return to this screen.
In order to stop the flushing cycle press Enter again, otherwise
the flushing cycle will continue till its regular completion.
10
Flushing counter
11
This screen displays the number of flushing cycles performed since the
last time this filed was cleared.
The controller stores a record showing the start time and reason
(PD, Time or Manual) for each one of the last 50 flushing cycles.
Use the Up and Down arrow keys to scroll through these
records.
Press Enter to edit and clear the flushing counter.
12
Battery
6.14 Volt
This screen shows the voltage of the controller’s battery.
The minimum operational level is 4.7 V