amiad BMF Series, Инструкции по установке, эксплуатации и обслуживанию

Страница: 8 / 51

Rev: 10.2017 BMF Pre-Engineered Skid IOM 8
often requires treatment for the control of corrosion, bacteria (including Legionella) and other
biological contaminants.
To control all potential contaminants, a comprehensive water treatment program must be developed
and employed. For specific recommendations on water treatment, a water treatment professional
should be consulted.
Factory Authorized Parts
Factory authorized parts are available through your Amiad representative. Please refer to Table 6 for
replacement parts. Contact the factory if assistance is required. Be sure to include the filter serial
number and model when ordering parts.
To facilitate servicing the unit, it is suggested that the following spare parts be carried on hand:
1. O-ring or gasket for filter tank access port and man hole
2. O-ring seal or gasket for pump pre-strainer lid (if applicable)
3. Pump Repair Kit (mechanical seal) – for systems with pumps only
Safety Precautions
All electrical, mechanical and rotating machinery constitute a potential hazard; particularly for those
not familiar with design, construction, and operation. Adequate safeguards (including use of
protective enclosures, when necessary) should be taken with this equipment both to safeguard the
public from injury and to prevent damage to the filtration equipment and the premises.
Filter system operation, maintenance and repair should be undertaken only by trained and qualified
personnel. All such personnel should be thoroughly familiar with the equipment, the associated
system and controls, and the procedures set forth in this manual. Proper care, procedures, and tools
must be used in handling, lifting, installing, operating, maintaining, and repairing this equipment, to
prevent personal injury and/or property damage.
For the protection of authorized service and maintenance personnel, the pump motor associated with
this equipment should be installed with a lockable disconnect switch located in close proximity and
within sight of the filtration system. No service work should be performed on or near the pump
motors without first ensuring that the pump motor has been electrically disconnected and locked out.
The re-circulating water system may contain chemicals or biological contaminants that could be
harmful if inhaled or ingested. Accordingly, personnel that may be exposed directly to the mist
produced by water jets or compressed air (if these are used to clean portions or components of the
filter) should wear respirators with HEPA filters, NIOSH/MSHA approved number TC-21C-142/TC-
21C182.