AMI AAA-N50W, Руководство по установке и инструкция по эксплуатации

Страница: 6 / 20

Installation Guide & Owner’s Manual – Under-the-Counter RO & Alkaline Drinking Water System
Copyright © 2019 WaterAnywhere.
All Rights Reserved.
Page 5
Preparing For Installation
Check the following list of components to ensure that all parts are packed with your system.
RO System
Manifold Assembly
Filter Housing
Sumps
Filter Cartridges
(Packed in Sumps) Storage Tank Faucet Kit
Drain Saddle
Feed Adapter Kit
(1/2” & 3/8”) Tank Valve
Filter Wrench
Membrane Wrench White Tubing
Recommended Tool List:
Have the below tools on hand before beginning installation. These are not included with the system.

Electric drill with ⅛ ”, ¼" & 7
/
16
” drill bits

1-¼” hole saw bit for faucet opening – appropriate for the surface
you are drilling

½” and
7
/
16
” open-end wrenches (or two adjustable wrenches)

Mounting screws or anchors appropriate for the surface you are
mounting to

Phillips screwdriver

Utility knife

Teflon tape (included)

Masking tape or duct tape
Check Location

Determine the location for the installation of the RO system. Avoid locations where the system might come
in contact with hot water pipes or other hazards.

Determine the location of the cold water feed line to use for the system supply.
Notice:
Accidentally hooking up the system to the hot water supply line will permanently
damage the membrane (see conditions for operation). To assure you are using the
cold water line, turn on both the hot and cold faucet. After the water is warm to the
touch, feel the pipes under the sink. It will be easy to identify the hot and cold pipes.

Determine the location for the faucet. Check to see that drilling the faucet hole will not damage pipes or
wires running underneath the sink.

Determine the location for the storage tank. A maximum distance from tank to faucet of 15 feet is possible
(additional tubing will be needed). The system will produce a faster flow at the faucet with the shortest
tubing run from tank to faucet.
Assemble Filter Housings onto System Manifold

Remove the plastic wrapping from the filter cartridges and insert each cartridge into a filter sump.

Making sure the o-ring stays seated properly, screw the filter sump onto the appropriate cap. The filters
should be installed in the following order of flow (left to right):
(1) Sediment Filter H-F1005CF
 (2) Carbon Filter H-F2510AC  (3) Carbon Filter H-F2510AC

Check to ensure the sump is tightly threaded onto the housing.