18
E. Adjust Photo cell device and level two platforms
1. Remove the cover of photo cell device on off-side platform firstly.
(See Fig.22)
2. Check by level bar and adjust the lower leveling bolts(
See Fig.23
), use the shims to
adjust the platforms until the front and rear of two platforms are in the same level.
Adjust the Upper leveling bolts(
See Fig.24
) after it touch the Lower leveling bolts
when lower to the lowest position. Then Tighten nut by wrench.
Check by
level bar
P1
P2
131
130
M4 bolts
Fig.
23
Fig.
24
Lower leveling bolts
Tighten nut
Tighten nut
Upper
leveling bolts
Fig. 22
Содержание DX-12A
