Seite 16 von 17
AMG Sicherheitstechnik GmbH
Industriepark Straße A-9
39245 Gommern
Telefon 039200-7797-0
Freecall 0800-2264264*
Fax 039200-7797-29
Geschäftszeiten sind von 8-17 Uhr, außerhalb dieser Zeit ist ein Anrufbeantworter geschaltet
*) kostenlos aus dem deutschen Festnetz und allen deutschen Mobilfunknetzen
Restart of the device
Send the command
reboot
via SMS to the GPS emergency transmitter.
The device restarts automatically without changing the settings.
Set device to factory settings
Send the command
RESET!
via SMS to the GPS emergency transmitter.
Note:
This command will reset all settings to factory defaults.
If you need to perform a device reset, then send an SMS with the command
S0
to
deactivate the GPRS data connection.
Please check afterwards with the SMS command
G1
the current data settings, here you
should see if GPRS is switched on (1), or off (0).
If it is on (1), please send the SMS command "S0", so that the connection is switched off
again.
Please also look at the green LED, when the device establishes a data connection, it
flashes twice briefly every 3 seconds, instead of just once.
ALL DATA GOES LOST !!!
Common mistakes
Error Description
Solution
The base station sounds a beep without being triggered
Presumably, external signals have been taught in, please
delete all learned signals (see page 8) and learn the radio
transmitters again, making sure that no foreign signals
register in the base
After changing / inserting the SIM card, the device does
not log in
Presumably the device was not correctly switched off
when removing / inserting the SIM card, please restart
the device (see page 9) and make sure that the device is
always completely switched off before removing a SIM
card.
The device sends wrong GPS coordinates
Presumably, the device has not yet been able to establish
a sufficient connection to the GPS satellite network,
please try to trigger the black handset under the open
sky. Note: for the GPS positioning a visual connection to
the sky is necessary, otherwise the device sends the last
known position, depending on the setting of the energy
saving mode, this can be very old, therefore is in the SMS
always the time (date, time) on this Position was
determined.