Step 2: Fix the transmitter flush with the window frame
When gluing, make sure that the
sensor is mounted flush with the
edge of the window sash or the
door. Attention: the adhesive pad
sticks very strong. A once attached
adhesive pad can not be detached
again. When the sensor is in the
correct position, press the sensor
firmly, the adhesive joint will reach
its final strength after about 1 hour.
Note: The sensor has a magnetic
switch contact at all 4 corners. This allows you to mount the sensor at any position
on the window or door. For switching only 1 magnet is needed at one of the 4
corners. An assembly as in the photos is only required if the window is
simultaneously monitored against opening and tilting or against glass breakage.
Step 3: Adjust the magnet to the desired height
The magnet is located in the head of the holder. You can adjust the necessary height
by pulling the upper part out of the holder and sticking on the supplied spacer.
