The small symbols have the following meaning:
Symbol S
(In the Picture Nr. 1) = Transmitter mode
This is the transmit mode with the lowest standby power consumption. In order to ensure
that the battery operates at the usual frequency of use for up to 1 year, the blue display
illumination is switched off in S mode after approx. 10 seconds and the display also
switches off.
The sensor is then in power-saving mode. To display the display again, press the right
button once to activate the display for 10 seconds.
Symbol Sun
= Pairing Mode
Programming mode is used for learning the sensors in the control panel. Also, the sensor
only in this mode can be reset (
reset
) the sensor shall be for a reset in programming
mode located (Sun symbol should Flash for this).
Press and hold seconds down the left and the big bottom button simultaneously for about
6-7. The sensor number displayed will change on 99 and the red and blue LEDs light up
briefly. This is the sign that the reset was successful. Now start the transmitter again.
After the reset, you must delete a transmitter from the control panel. Other
symbols on the display are for internal purposes only. These have no meaning for
you.
