AMF REECE S-105, Руководство по эксплуатации и ремонту

Страница: 32 / 68

Revised 12/2007
E-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
S-105
1-20
The standard range of seaming width – from 1,9 up to 3,0 mm can be changed by loosing the nut Ê Ê
Ê Ê Ê
,
shifting it between the stops and tightening it again.
6 . C H A N G I N G S E A M I N G W I D T H
WARNING: When adjusting this device, check the needle position against the hole for gimp in the stitching
plate. The needle tip must not go through the hole during centre and side prick. This way you can check
that the gimp will be sewn between the stitching rows.
Ê Ê Ê Ê Ê
C - CORRECT USAGE
The supplied machine is a box-type piece of equipment with an optimally raised working area above the
table desk. The arm with the sewing mechanism is placed in the folding frame to adjust and pull in threads.
The machine is installed onto the stand so that it suits an seated operator.
Machines are adjusted “cut after sewing” (CA) at the manufacturer, unless specified otherwise. The base
position of a working plate of such adjusted a machine is in its rear dead point. After the start of the
machine, the plate moves towards the operator, during which time the clamps clamp the work piece and
the plate moves to the point where the buttonhole sewing is suppose to start. The feet automatically stretch
the work piece in order to ensure high quality of sewing. The size of opening is adjustable. The sewing
mechanism automatically starts sewing in the place of the buttonhole by releasing the clutch of the drive
shaft and the buttonhole is sewn. The starting moment and the buttonhole length can be adjusted by
changing the cutting steel, possibly the knife too.
Once the sewing of a buttonhole is finished, the needle is set in the upper position and the plate moves to
the position where upper thread is trimmed. After that, the work piece is cut, the clamps open themselves
and the work piece is released. The whole cycle, excluding the sewing, can be run by the hand wheel on
the left side of the machine under the removable cover.
The machine operation can be stopped immediately with the operational switch (breaker) or table pedal.
5 . M A C H I N E D E S C R I P T I O N A N D I T S F U N C T I O N S