AMF-BRUNS Hydraulic Lowering Rear Suspension, Руководство по эксплуатации

Страница: 24 / 40

De-Commissioning and Conservation
Page 24 of 40 Hydraulic Lowering Rear Suspension
7 De-Commissioning and Conserva-
tion
For queries regarding de-commissioning and conservation,
contact our customer services department (see Chap-
ter 12, page 37).
8 Faults and Troubleshooting
WARNING!
Risk of injury and material damage if repair work is carried
out incorrectly.
Therefore:
Only allow specialist personnel to carry out repair work.
If faults occur when operating the Lowering Rear Suspen-
sion, proceed as described in the following troubleshooting
table. Contact the customer service department if faults
are encountered which cannot be remedied using the in-
formation and measures given in the table.
Fault (possible) Cause Remedial Measures
The vehicle does not
lower.
The 100 A fuse has blown. Replace the fuse.
The vehicle's battery is
discharged or defective.
Check the vehicle's battery
and re-charge or replace it as
necessary.
The hydraulic reservoir is
empty.
Top up with ATF fluid.
Attention:
If the reservoir is over-
filled, fluid will be forced
out through the filler cap
and bleed screw.
The electrical or hydraulic
system is defective.
Have the lowering rear
suspension checked in a
specialist workshop
The vehicle does not
raise.
The lowering valve is jammed
or defective.
Have the lowering valve
cleaned or replaced in a
specialist workshop.
The vehicle lowers but
raises again slowly.
The seals on the hydraulic
cylinders are leaking.
Have the hydraulic cylinders
replaced in a specialist
workshop.