Amewi PITBULL X EVOLUTION, Инструкция по эксплуатации

Страница: 8 / 25

INSTRUCTION MANUAL PITBULL X EVOLUTION
8
BIND TRANSMITTER
Transmitter and receiver are already factory-
matched and can be used immediately. A
renewal of the binding is only necessary after
a receiver or transmitter change or to remedy
a mistake.
Proceed as follows:
1. Turn off the transmitter.
2. Plug the binding cable into the "Ch 3"
socket on the receiver.
3. Connect the receiver battery to the
receiver.
4. The LED on the receiver starts to flash
5. Press and hold the binding button on the transmitter while turning on the transmitter.
6. When the LED on the receiver stops flashing, the binding process is complete.
This may take a few seconds Release the binding button on the transmitter and pull. Disconnect the
binding cable from the receiver.
7. Check the function of the servo and the range of the remote-control system. If the servo does not
respond correctly, repeat the process
FAIL SAFE / FAIL SAFE
The Fail-Safe function prevents that the in case of a
signal loss, the car is out of control.
This function must be set before the first start and
checked before every start.
Set Fail Safe:
1. Turn on transmitter
2. Connect battery to receiver
3. Check the connection.
4. Push the throttle trigger to the max position (full
brake)
5. Press the set button on the receiver
6. The led flashes, the fail-safe is saved.
Please check the function. Turn off the transmitter. Now the throttle servo should automatically go to the
braking position. If not, repeat the process.
LED
Bind plug
Set button