Amewi 26079, Инструкция по эксплуатации

Страница: 24 / 32

BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL DRAGONFLIGHT 95
amewi.com
Rudder should turn to the right. When the Sail Winch control stick is moved down, the clip on the Winch
Line should move to its furthest back position.
4. With the rudder control stick and fine adjuster on the Transmitter set in their central position, check to
see if the Rudder Blade is centred in line with the Keel when viewed directly from behind. If not, use the
Allen Key to adjust the top grub screw on the Rudder Arm.
5. Using your Tx (see manual), adjust the rudder throw to approximately 40 degrees from the centreline in
either direction when the rudder control stick is moved to its maximum throws.
6. Now set the required Winch Line travel of 115mm between the fully sheeted in position (for sailing
‘close hauled’
-
close to the wind) and fully sheeted out position (for sailing on a ‘run’
- sailing in the
same direction as the wind with the sails fully out) (see diagram 5 below). Refer to your Tx manual on
how to make this adjustment. Check that the elastic tensioner on the Winch Line is still under light
tension in the ‘sheeted out’ position, if not, shorten the elastic until this is achieved (this tension stops
the Winch Line from jumping off the Winch Drum).
Note: It’s a good idea to mark these two positions on the
deck as a permanent reference points for
consistent sheeting adjustment. The sheeting points shown are not too critical but what is important is
the amount of travel between the two points of 115mm. On computerised Transmitters you will be able
to adjust the sheeting end points individually through their software menus.
Kanal 5 / CH5
Schalter
Switch
Kanal 3 / CH3
Segelwinde
Sail Winch
Kanal 1 / CH1
Ruderservo
Rudderservo
1 2 4
5