BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL AFX180
15
The remote control and receiver are already connected when delivered. However, you may have to re-establish the connection at
another time. The procedure is described below.
1.
Switch on the transmitter, make sure the throttle stick is in the bottom position and 3D/Idle switch in the OFF position.
2.
Take down the canopy for touching the bind switch.
3.
Connect the battery to the controller, the control lamp of the receiver flashes. Press the bind button for one second, then the
red LED will go out and get ready for pairing.
4.
When the red and blue lights turn solid, the pairing has been successful.
5.
Make sure that there is no other remote control of the same type in the vicinity during the binding process in order to avoid
interference.
6.
If the connection cannot be established, perform the steps described above again.
Note:
1.
If the TH.HOLD switch is in the on position while the remote control is turned on, a beeping sound will be heard. Turn the
TH.HOLD switch to off. 2.
2.
If the 3D switch is in the on position while the remote control is turned on, a beep will sound. Turn the 3D switch to off.
3.
If the throttle is not in the lowest position when the remote control is turned on, a beep will sound. Pull the throttle lever to
the lowest position.
GAS- UND PITCH KURVE /
THROTTLE AND PITCH CURVE
