Ametek Sorensen SG Series, Руководство по программированию

Страница: 85 / 149

SG Series Programming SCPI Command Operation
M550129-03 Rev L
6-19
Command Description SCPI
:FOLD
<0|1|2>
Sets the foldback (program down) mode of the supply. Valid
arguments are 0 (OFF or do nothing, do not program down to zero),
1 (program down to zero upon entering constant-voltage mode), or
2 (program down to zero upon entering constant-current mode).
N
:FOLD?
Returns the set foldback (program down) mode of the supply.
0 = OFF; will not program down.
1 = will program down to zero upon entering constant-voltage
mode.
2 = will program down to zero upon entering constant current mode
N
:SENSe
<boolean>
Sets the sense relay signal open or close. Valid arguments are
1/ON or 0/OFF.
N
:SENSe?
Returns the setting of the sense relay signal:
1 = ON 0 = OFF
N
:STATe
<boolean>
Sets the output to zero or the programmed value; opens or closes
the isolation relay. Valid arguments are 1/ON or 0/OFF. *RST
state value is ON.
C
:STATe?
Returns the state of the output:
1 = ON 0 = OFF
C
:TRIPped?
Returns the integer value 1 (TRIPPED) or 0 (UNTRIPPED) state of
the output.
N
6.8
STATUS SCPI COMMAND SUBSYSTEM
This section first presents a tree summary of the STATus commands and
then provides a tabular description.
Note: See Section 5 for further information.
6.8.1
STATUS SCPI Command Summary
STATus
:OPERation
:CONDition?
:ENABle <NR1>
:ENABle?
:EVENt?
:PRESet
:PROTection
:CONDition?
:ENABle <NR1>
:ENABle?
:EVENt?
:SELEct <NR1>
:SELEct?
:QUEStionable
:CONDition?
:ENABle <NR1>
:ENABle?
:EVENt?