Ametek Gemco 1995L, Инструкция по установке и программированию

Страница: 16 / 33

Chapter 3: Programming
Installation and Maintenance Manual 12
3.16: Power-Up in Position or RPM
The 1995L can power up displaying either Position or Scale Factor increments/sec. data.
The power-up mode is programmed by entering the following:
A) Unit must be in the “Program” mode.
B) Depress . If a zero (0) is entered, ENT CIR# - 1 - 6 3
- -
(0 or 1)
-
ENT
-
positional data will be displayed upon power-up; if a one (1) is entered, the unit will power up
displaying Scale Factor increments/sec.
3.17: Decimal Point Programming
A continuous, nonfloating decimal point may be programmed on the display. If a scale factor is selected
that needs a decimal point in order to properly display its resolution in engineering units, the following 50
series codes are used:
50 - No decimal point;
clears existing decimal point 123
51 - Tenths 12.3
52 - Hundreths 1.23
To program a decimal point, enter the following:
A) Unit must be in the “Program” mode.
B) Depress .
Example: CIR# 50 = 123
CIR# 51 = 12.3
CIR# 52 = 1.23
ENT CIR# - 50 or 51 52
or -