AmeriGlide Rave 2, Руководство по установке

Страница: 15 / 24

RAVE II STAIR LIFT:
Install Manual
04DEC2020 | 630-00078 REV G
15
INSTALLATION
RAVE II STAIR LIFT: SECTION 4
PROCEDURE TO SWITCH
ARMREST CONTROL FROM
RIGHT TO LEFT HAND
1. Turn the red "On/Off" switch located on the
top of the chassis to the "Off" position.
2. Flip up armrests and remove the screws on
both armrests.
See Figure 4-30.
Figure 4-30
3. Once the screws are removed, fold the
armrests to the down position and slide the
pad assembles forward until they come off,
then unplug each connector. See Figure 4-31.
Figure 4-31
4. Rotate the pad assembles to the opposite
sides and plug in the connectors on each
armrest. See Figure 4-32.
Figure 4-32
5. Snap both armrests into place and replace the
screws. See Figure 4-33.
Figure 4-33
6. Flip the armrests back down, turn the red "On/
Off switch located on the top of the chassis
to the "On" position. You should hear a single
beep. Test the control switch on the armrest.
See Figure 4-34.
Figure 4-34
NOTE: It may be necessary to locate the retractor portion
of the seatbelt on the downward side of the lift to
maintain close distance to the wall.