O
p
er
at
ion
In
st
al
lat
ion
A
p
pe
ndi
x
Tr
o
u
b
les
ho
o
ti
ng
C
o
de
B
lue
Clo
ck
Co
nf
igu
rat
ion
Wi
-F
i
Co
nf
igu
rat
ion
Ad
m
in
is
tr
at
or
Se
tt
in
gs
In
tr
od
u
c
tio
n
S
p
ec
if
ic
at
ions
© American Time
18
Wi-Fi Digital Clock/Elapsed Time Indicator
with Code Blue Installation Manual
Introduction
The clock will act as a limited access point for direct Wi-Fi communication to complete configuration.
After connecting to the clock with a wireless device it can be configured with a web browser.
n
Note:
If your clock was preconfigured by American Time this process is unneeded unless changes are required.
Digital Configuration
To enter configuration (limited access point mode) complete the following process:
Ensure that the clock is powered up and move the Run/Set switch from Run to Set. The clock will display a
scrolling message:
SEtUP
. Press the Enter button and the clock Wi-Fi module will go into provisioning mode.
1. Connect to the clock with a Wi-Fi enabled device (SSID will show up as American Time - xxxxxx
under available wireless networks, where xxxxxx is the last 6 digits of the mac address.
2. Enter
192.168.240.1
into the URL of a web browser of the Wi-Fi enabled device.
3. Refer to Clock Configuration (page 21) to configure clock settings and
Wi-Fi Configuration (page 22) to configure Wi-Fi settings.
4. When the clock Wi-Fi module is connected to the Wi-Fi enabled device, the clock will
scroll the message:
CANCEL
across the screen. Press the Enter button to cancel the
provisioning and disconnect the Wi-Fi module from the Wi-Fi enabled device.
Configuration (Limited Access Point Mode)
