M 9 6 8 8 3 2 R e v . 1 . 3
CHECK DRAIN CONNECTIONS
11
12
13
14
TEST INSTALLED FITTING
With HANDLES
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
Remove AERATOR
(3)
.
Operate both HANDLES
(1)
to flush water
lines thoroughly.
Replace AERATOR
(3)
.
1
HOT
COLD
2
4
2
1
SERVICE
“P” TRAP
WASTE
OUTLET
3
Operate POP-UP KNOB
(5)
and fill Sink with water. Check
that DRAIN STOPPER
(4)
makes a good seal and retains
water in Sink. If STOPPER
(4)
does not seal properly, please
refer to “Troubleshooting Guide” in these instructions.
Release POP-UP KNOB
(5)
down and check all drain
connections and
"P"
trap for leaks. Tighten
if necessary.
4
10
INSTALL HANDLES
1
2
4
5
3
TOP
Figure "A"
SPLINE END DOWN
Push ADAPTER
(1)
on VALVE STEM
(2)
, so that the hole of the
ADAPTER
(1)
without a spline is facing up. See
figure "A"
. Tighten
STEM SCREW (3) to secure ADAPTER
(1)
.
Find correct position of LEVER HANDLE ASSEMBLY
(4)
by adjusting
male teeth on ADAPTER
(1)
to female teeth in HANDLE
(4)
.
Thread LEVER HANDLE ASSEMBLY
(4)
onto DECK ADAPTER
(5)
until snug against mounting surface
.
THREAD ON
TO DECK
ADAPTER
2
90˚
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position. Unthread HANDLE
BASE
(1)
from DECK ADAPTER
(2)
.
Pull HANDLE ASSEMBLY off VALVE STEM
(3)
.
Remove SPRING CLIP
(4)
. Lift STOP WASHER
(5)
,
turn 90˚ and replace. Replace SPRING CLIP
(4)
.
Find correct position of HANDLE ASSEMBLY by adjusting
male teeth on VALVE STEM
(3)
to female teeth in HANDLE.
Thread HANDLE ASSEMBLY onto DECK ADAPTER
(2)
until snug against mounting surface.
If spout drips, operate handles several times from
OFF to ON position. Do not force - handles turn
only 90˚ .
1
4
3
5
UNTHREAD
HANDLE
ASSEMBLY
5
DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER.DRY
WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
CARE INSTRUCTIONS:
