2
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES
(1, 2)
directly
to wall supplies. Connection on fitting
supplies are 3/8" compression. Connect
left supply to Hot
(Marked with a Red Line)
and right supply to Cold wall supply. Use
adjustable wrench to tighten connections.
Do not over tighten.
Faucet supplies are 21" long from faucet base.
Note: If additional supply length is
required, installer must purchase
additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
4
TEST INSTALLED FAUCET
3
Place WASHER
(3)
into COUPLING NUT
(1)
on HOSE
(2)
. Thread COUPLING NUT
(1)
onto
HAND SPRAY
(4)
and tighten.
(May already be assembled).
Slide COUPLING NUT
(1)
onto HOSE
(2)
Feed small end of HOSE
(2)
through BODY
(5)
so
HAND SPRAY
(4)
rests inside SPRAY HOLDER
(6)
.
Thread HOSE END
(7)
onto OUTLET HOSE ADAPTER
(8)
and tighten.
CONNECT SPRAY HOSE
Move HANDLE
(1)
down into "off"
position.
With HANDLE
(1)
down in "off"
position.
Turn on water supplies.
Operate handle up and down, in COLD and HOT positions, to
flush water lines thoroughly.
Place WASHER
(7)
into HOSE END
(4)
and connect
HAND SPRAY
(2)
to HOSE END
(4)
. Place HAND SPRAY
(2)
back into faucet.
Pull HAND SPRAY
(2)
from FAUCET
(5)
and disconnect HAND SPRAY
(2)
. Be
careful not to lose WASHER
(7)
. Pull
HOSE
(3)
(HOSE should pull
approximately 2 feet) and direct open
HOSE END
(4)
into sink.
Check HAND SPRAY
(2)
operation:
With faucet on push front of BUTTON
(6)
for a broad
cleansing spray.
With HAND SPRAY
(4)
seated in SPRAY HOLDER
(6)
,
install WEIGHTS
(9)
onto HOSE
(2)
using two SCREWS
(10)
.
Locate the WEIGHTS
(9)
two feet
(2')
from the underside of
the sink deck. Tighten SCREWS
(10)
firmly.
1
5
3
2
4
6
7
2
9
10
8
1
3
5
2
6
4
24"
7
Check connections for leaks
(See
Section 5).
M 9 6 8 4 7 0 R E V. 1. 5
1
2
COLD
HOT
