CHECK DRAIN CONNECTIONS
10
11
12
TEST INSTALLED FITTING
With HANDLES
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
Remove AERATOR
(3)
.
Operate both HANDLES
(1)
to flush water
lines thoroughly.
Replace AERATOR
(3)
.
Operate POP-UP KNOB
(5)
and fill Sink with water. Check
that DRAIN STOPPER
(4)
makes a good seal and retains
water in Sink. If STOPPER
(4)
does not seal properly, please
refer to “Troubleshooting Guide” in these instructions.
Release POP-UP KNOB
(5)
down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
4
DO: CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES,
HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
CARE INSTRUCTIONS:
90˚
90˚
4
HOT
13
SERVICE
To change direction of handle:
1
1
COLD
2
2
“P” TRAP
5
WASTE
OUTLET
3
6
7
1
2
3
4
RED
5
BLUE
8
9
9
Turn valves to OFF position.
Turn off water supplies.
Loosen SET SCREW
(1)
with 5/64" HEX WRENCH
(2)
.
Pull HANDLE
(3)
“UP” firmly to release from
PLASTIC INSERT
(4, 5 or 6)
.
Remove SCREW
(7)
and pull off PLASTIC INSERT
(4, 5 or 6)
.
Remove RETAINING O-RING
(8)
.
Lift and turn STOP WASHER
(9)
90˚.
Replace RETAINING O-RING
(8)
.
Re-install HANDLE ASSEMBLY.
AERATOR may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR
and rinse to clear any debris.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
M965622 Rev. 1.2 (12/17)
