M965263 REV. 1.9 (8/17)
3mm
HEX WRENCH
FRICTION WASHER
Pull out INDEX BUTTON
(1).
Loosen HANDLE SCREW
(2)
with 2.5mm Hex Wrench, then
pull HANDLE
(3)
off.
Unthread ESCUTCHEON CAP
(4)
. Unthread the CARTRIDGE NUT
(5)
.
Remove CARTRIDGE
(6)
. Clean inlets of CARTRIDGE
(6)
and MANIFOLD
(7)
.
Reassemble CARTRIDGE
(6)
. Replace CARTRIDGE NUT
(5)
, CAP
(4)
and HANDLE assembly, check flow.
SERVICE
Clogged CARTRIDGE outlets or inlets may cause reduced
flow.
To clean, first turn off water supply then:
2
11
3
1
4
5
6
7
If SPOUT (10) leaks at swivel point the O-RINGS (9) need
to be replaced. To remove SPOUT (10)
:
Loosen the SPOUT SET SCREW
(8)
with a 3mm Hex wrench. (Supplied)
Rotate the SPOUT
(10)
side to side while pulling upward to remove SPOUT
(10)
from faucet body.
Replace the defective parts and grease O-RINGS
(9)
with plumber’s grease. Push SPOUT
(10)
back into position.
Tighten SET SCREW
(8)
.
Check that SPOUT
(10)
rotates freely and does not leak at the swivel point.
REMOVE
INSTALL
10
9
8
CLEAN
AERATOR
(11)
and HOSE FILTER SCREENS
(12)
may accumulate debris causing distorted or reduced water flow.
Remove AERATOR
(11)
and/or water supplies and rinse clean.
12
6
