. 3 & 7
Operate Lift Rod
(3)
and fill Bidet with water. Check
that DRAIN STOPPER
(4)
makes a good seal and
retains water in Bidet. Adjust stopper height by
repositioning Lift Rod
(3)
and tightening
Thumbscrew
(5)
.
Release DRAIN STOPPER
(4)
and check all drain
connections for leaks.Tighten if necessary.
TEST INSTALLED FITTING
With HANDLES
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
Operate both handles to flush water lines thoroughly.
Turn DIVERTER
(6)
to rim wash and bidet spray.
1
3
2
2
6
5
4
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean
water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
EverClean™ Finish Care Instructions
SERVICE
TO CLEAN SPRAY
Replace SPRAY
(6)
and operate handles several times from OFF
to ON position. Do not force, handles turn only 90˚.
SPRAY
(6)
may accumulate dirt causing distorted and reduced
water flow. Unscrew and remove SPRAY
(6)
and rinse clean.
6
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position. Unthread HANDLE BASE
(1)
from DECK ADAPTER
(2)
.
Pull HANDLE ASSEMBLY off VALVE STEM
(3)
.
Remove SPRING CLIP
(4)
. Lift STOP WASHER
(5)
, turn 90
p
and replace. Replace SPRING CLIP
(4)
.
Find correct position of HANDLE ASSEMBLY by adjusting male
teeth on VALVE STEM
(3)
to female teeth in HANDLE.
Thread HANDLE ASSEMBLY onto DECK ADAPTER
(2)
until
snug against mounting surface.
2
90
p
1
4
3
5
UNTHREAD
HANDLE
ASSEMBLY
