background image

7 3 0 8 6 5 - 1 0 0   R e v .   H

-   4   -

Does not flush

Poor or sluggish flush

Toilet leaks

Toilet does not shut off

a.  Water supply valve closed.

b.  Supply line blocked.

c.  Flush valve chain too loose or disconnected.

d.  Sand or debris lodged in water control.

a. Bowl water level too low.

b.  Supply valve partly closed.

c.  Partially clogged trapway and/or drain pipe and/or vent.

d.  Supply pressure too low.

e.  Flush valve chain too tight, holding flush valve open.

a.  Poor supply line connection.

b.  Poor bowl to tank/floor connection.

a.  Flush valve seal leaking or deformed.

b.  Sand or debris lodged in water control.

a.  Open valve and allow water to fill tank.

b.  Shut off water supply, disconnect supply line and inspect all            
     gaskets and washers. Reassemble. Also, see Fluidmaster  

     

     maintenance. (see Step 13)

c.  Readjust chain length as required.

d.  Shut off water supply. Remove cap and clean as per Step 13.

a.  Check that refill tube is connected to water control and  

     

     inserted into tank overflow without being kinked or damaged.        
     (see Step 11a)

b.  Open supply valve fully. Be sure that proper supply tube size        
     is used.

c.  Remove obstruction. Consult a plumber if necessary.

d.  Normal supply pressure must be at least 20 psi.

e.  Readjust chain length as needed. Review Step 9b.

a.  Review Step 8 of installation procedure.

b.  Review Step 4 through 6 of installation procedure.

a.  Clean debris from seal surface. Replace flush valve seal as  

     

     needed. (see Step 11)

b.  Shut off water supply. Remove cap and clean as per Step 13.

TROUBLESHOOTING GUIDE

PROBLEM

POSSIBLE CAUSE

CORRECTIVE ACTION

CHAMPION® 4 FLUSHING SYSTEM TEN-YEAR WORRY-FREE™ LIMITED WARRANTY

For this warranty to become effective, the accompanying warranty registration card and proof of purchase must be completed and returned to the address on 
the warranty registration card within 30 days of purchase.
If inspection of this American Standard plumbing product, inclusive of china and all mechanical components, within ten years after its initial purchase, 
confirms that it is defective in materials or workmanship, American Standard will repair or, at its option, exchange the product for a similar model. 
This warranty

 does not apply

 to local building code compliance.  Since local building codes vary considerably, the purchaser of this product should check 

with a local building or plumbing contractor to insure local code compliance before installation.
This warranty 

shall be void

 if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse, misuse, 

accident or other damage; if it was not installed in accordance with American Standard's instructions; or if it has been modified in a manner inconsistent with 
the product as shipped by American Standard.
This warranty 

DOES NOT COVER

 any damage caused by the use of in-tank cleaners.

American Standard's option to repair or exchange the product under this warranty does not cover any labor or other costs of removal or installation, 

nor shall 

American Standard be responsible for any other incidental or consequential damages attributable to a product defect or to the repair or exchange 
of a defective product, all of which are expressly excluded from this warranty.

 (Some states or provinces do not allow the exclusion or limitation of 

implied warranties, so this exclusion may not apply to you.)
This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to province, in which case this 
warranty does not affect such statutory rights.
For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the product was purchased, or 
that a service request (including a description of the product  model and of the defect) be sent  to the following address:

In the United States:

American Standard Inc.

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of  Consumer Affairs

For residents of the United States, warranty 

information may also be obtained by calling 

the following toll free number: (800) 442-1902

www.americanstandard-us.com

In Canada:

American Standard

2480 Stanfield Rd.  

Mississauga, Ontario 

Canada L4Y 1S2

Toll Free:  (800) 387-0369

www.americanstandard.ca

In Mexico:

Customer Service Manager 

Ideal Standard, S.A. de C.V.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico

www.americanstandard.com.mx

REPAIR PARTS LIST

NOTE: 

"XXX" represents color or trim finish options. Specify when ordering.

Repair parts are determined by toilet tank number which can be found marked inside tank.

PART NO.

2004.014

2004.314

2034.014

2034.314

2034.004

DESCRIPTION

Champion

®

4 Trip Lever Assembly

Champion

®

4 Chinaware Tank Cover

Champion

®

4 Seat

Champion

®

4 Water Control Assembly

Champion

®

4 Valve Seal Kit

Champion

®

4 Flush Valve Assembly

Champion

®

4 Adapter Assembly - Kit #247

Champion

®

4 PVC Refill Tube

Champion

®

4 Clevis Pin Assembly

Traditional Trip Lever Assembly
Traditional Chinaware Tank Cover
Traditional Seat
Traditional Bolt Cap Kit
Bolt Cap Kit - #128
Refill Tube Clip

738772-XXX0A
735105-XXX0A
5325.01.XXX
738565-425.0070A
7301111-0070A
3280.040-0070A
738826-0070A
738570-1020A
738985-0070A
738963-XXX0A
738126-XXX0A
5260.012.XXX
7301134-XXX0A
034783-XXX0A
072989-0070A

Содержание Elongated One-Piece Toilet 2003

Страница 1: ...4 29 3 4 756mm 8 203mm 1 3 4 44mm 1 1 4 32mm 15 381mm 13 1 2 343mm 10 3 4 273mm 28 1 8 714mm 16 3 4 425mm 17 3 4 451mm FINISHED WALL 18 1 2 470mm C L OF SEAT POST HOLES 5 1 2 140mm CENTERS 12 305mm 1 2 13mm 10 3 4 273mm 4 1 2 114mm SUPPLY AS REQ D FINISHED FLOOR 7 178mm 4 102mm CLOSET BOLT NUT TAPERED WASHER FLANGE Recommended fitting type for back to back installations Depending upon your plumbin...

Страница 2: ... of valve does not apply to flanged tubing Use existing coupling nut and washer Use existing spiral cone washer Fluidmaster cone washer may not seal completely on spiral type supply line Captive cone washers already included No additional washers needed CAUTION Overtightening of LOCK NUT or COUPLING NUT could result in breakage and potential flooding METAL COPPER FLARED TUBING METAL FLANGED TUBING...

Страница 3: ...ster will be replaced without charge Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products Fluidmaster shall not be responsible or liable for any damages caused by products used with Fluidmaster valves that were not manufactured by Fluidmaster Inc See next page for Champion 4 Ten Year Worry Free Limited Warranty 30800 Rancho Viejo Road San Juan Capistrano CA 92675 ...

Страница 4: ...se accident or other damage if it was not installed in accordance with American Standard s instructions or if it has been modified in a manner inconsistent with the product as shipped by American Standard This warranty DOES NOT COVER any damage caused by the use of in tank cleaners American Standard s option to repair or exchange the product under this warranty does not cover any labor or other co...

Отзывы: