- 2 -
2
3
MAKE WATER SUPPLY CONNECTIONS
CONNECT HOSE SPRAY and INSTALL WEIGHT
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLIES
(1, 2)
directly to wall supplies.
Connection on fitting supplies are 3/8" (10 mm) compression.
Connect left supply (Marked with a Red Stripe) to Hot and right
supply (Marked with Blue Stripe) to Cold wall supply. Use
adjustable wrench to tighten connections. Do not over tighten.
• Faucet supplies are 27-1/2" (699 mm) long from faucet base.
Note:
If additional supply length is required, installer must
purchase additional parts separately.
Impor tant:
If SUPPLY HOSES
(1, 2)
are too long, loop as
illustrated to avoid kinking.
• Check that seal washers are installed in both ends of
SPRAY HOSE ADAPTER
(1)
. Thread SPRAY HOSE
ADAPTER
(1)
onto faucet SHANK
(2)
.
Tighten with adjustable wrench.
Figure 1.
• Thread HOSE END
(3)
into bottom of SPRAY HOSE
ADAPTER
(1)
. Tighten with adjustable wrench.
Make sure all connections are tight.
Figure 1.
• Install RUBBER BUSHING
(4)
onto SPRAY HOSE
(5)
.
Install WEIGHTS
(6)
onto HOSE
(5)
using two screws
(7)
. Locate WEIGHTS
(6)
18” from underside of
mounting surface on HOSE
(5)
. Tighten
SCREWS
(5)
firmly.
Figure 2.
M965559 Rev. 1.5 (3/15)
1
INSTALL FITTING
CAUTION
Turn off hot and cold wate
supplies before beginning.
• Make certain the O-RING SEAL
(1)
is properly seated in recess of faucet body.
• Insert supply HOSES
(2)
, SHANK
(3)
and SPRAY HOSE
(4)
through center hole
of sink or mounting surface.
• Assemble RUBBER WASHER
(5)
, PLASTIC WASHER
(6)
, RUBBER & METAL
“C” WASHERS
(7)
and long LOCKNUT
(8)
onto SHANK
(3)
from underside of sink.
Hand tighten LOCKNUT
(8)
and check that faucet is centered.
• Tighten LOCKNUT
(8)
with WRENCH.
• Feed HOSE END
(9)
through HOSE GUIDE
(10)
. Slide other side of HOSE GUIDE
(10)
onto SHANK
(3)
and secure with LOCK NUT
(11)
. Do not over tighten!
1
3
2
5
7
6
8
9
10
11
RECESS
4
RED
STRIPE
BLUE
STRIPE
1
2
COLD
HOT
Figure 2
SEAL
WASHER
SEAL
WASHER
2
1
3
5
7
6
4
UNDER SIDE
OF MOUNTING
SURFACE
Figure 1
18"
(457mm)
