Perimeter
of sink
Cutout
1
Drill a clearance hole
inside the cutout line
as marked on the
countertop.
AFTER THE CUTOUT IS DRAWN...
© A M E R I C A N S T A N D A R D I N C . 2 0 0 2
Perimeter
of sink
Cutout
2
A
B
Single Bowl
Double Bowl
Trap
Trap
3
5
4
6
8
9
7
Connect supply lines
to faucet finger tight,
and carefully bend to
engage with the
supply stops. Tighten
connections to faucet
for secure seal.
Connect drain assembly
hand tight to check align-
ment. It may be necessary
to cut off part of the
tailpiece (area "A") or part
of the horizontal leg of the
trap (area "B").
Secure joint for watertight
assembly.
7 9 0 7 6 7 - 1 0 0
2
1/8"
Masking
tape outline
Sink
outline
Cutout
Mount the faucet and
drain assembly on the
sink or countertop
following the
manufacturer's
instructions.
Note: The clips supplied with sink can be used for
a countertop with a thickness of 1/2" min. to 1"
max. If countertop excedes 1" thickness you must
request clips for the larger thickness. Part No.
790772-0070A. If a plug is required to cover an
unused hole, order Part No. 790773-0070A.
Before applying the sealant,
place the sink temporarily
into the cutout. Check for
alignment and clearance,
then trace around the
outside edge of the sink as
a guide for installation
location and application
of sealant.
Cut opening on cut line
inside the perimeter of sink.
Note - Formica countertop
installation only is illustrated.
Contact your countertop
distributor for the best method
of cutting other materials such
as marble, hard synthetics,
etc.
Remove sink and
apply a masking tape
outline 1/8" outside
traced outline as a
guide for application
of silicone sealant.
LOCKING TAB
NOTCH
Place a retaining clip onto hold-down rib. Make
certain locking tab engages depression in
hold-down rib. Approximate locations shown
on page 3 for correct model.
10
11
12
Rotate each
retaining clip
toward sink bowl.
Apply a generous portion of sealant inside line
traced on countertop. Carefully lower sink into
cutout and press down firmly. Use guidelines
for proper positioning.
Rotate each clip to
engage countertop.
NOTE - TIGHTEN
THE TWO CENTER
CLIPS ON EACH
LONG SIDE OF THE
SINK FIRST ( SEE
FIGURE 3 FOR DETAILS). Complete the
tightening process for the remaining clips,
to secure sink. Remove excess sealant from
countertop for a smooth even line of sealant
around the edge of the sink.