DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER. DRY
WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
CARE INSTRUCTIONS:
CHECK DRAIN CONNECTIONS
11
10
12
TEST INSTALLED FITTING
With VALVE
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
Remove AERATOR
(3)
.
Operate both HANDLES
(1)
to flush water
lines thoroughly.
Replace AERATOR
(3)
.
1
HOT
COLD
2
4
2
1
5
“P” TRAP
WASTE
OUTLET
3
Operate POP-UP KNOB
(5)
and fill Sink with water. Check
that DRAIN STOPPER
(4)
makes a good seal and retains
water in Sink. If STOPPER
(4)
does not seal properly, please
refer to “Troubleshooting Guide” in these instructions.
Release POP-UP KNOB
(5)
down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
4
13
14
SERVICE
TO CLEAN AERATOR
Replace AERATOR
(3)
and operate handles several times
from OFF to ON position. Do not force, handles turn only 90˚.
AERATOR
(3)
may accumulate dirt causing distorted
and reduced water flow. Unscrew and remove
AERATOR
(3)
and rinse clean.
INSTALL HANDLES
90˚
Turn off hot and cold water
supplies before beginning.
CAUTION
See separate instruction sheet supplied with handle kit for handle
installation.
1
2
AERATOR may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90
°
.
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP
(1)
.
Lift STOP WASHER
(2)
, turn 90
°
and replace.
Replace SPRING CLIP
(1)
.
Replace ADAPTER, HANDLE, SCREW, and
INSERT.
M966230 Rev. 1.2
