760294-100
- 7 -
CLEANING AND MAINTENANCE
Insecticide
Abrasive
paper
Painting thinner
Regulator
A
B
DO NOT USE AGGRESSIVE CHEMICALS:
for example: hydrogen chloride, paint thinner, benzene,
You will need to clean the wands when they get build up
of residue and calcium. You can pull the wands out with
your finger and then with a soft bristle toothbrush, brush
the nozzle head.
by pressing the
release button on the
right side of the
SpaLet seat and
sliding the seat
forward as shown.
This enables you to
be able to clean more
thoroughly around the
toilet. Make sure to
disconnect the
connection hose
before you do this.
The incoming water pressure is regulated by a regulator
insert. This can be removed and replaced.
First turn off the water supply and disconnect the connection hose.
Rotate the lever to the on position, pull out the regulator from the
inlet tube with needle-nose pliers.
Press the new regulator into the inlet tube.
Then rotate the lever back to non-working position.
If anything shall leak, retighten the connection and use teflon
tape if needed. If water leaks from the two ends of the water
hose, retighten the nuts to avoid water leaking
The nozzles can be removed if needed for cleaning.
First turn off the water supply to the SpaLet seat.
As per figure A, pull out the tube and remove the old nozzle by pulling out straight, as shown.
As per figure B, insert the new nozzle into the tube along the corresponding slot.
You can remove
the SpaLet seat
If you start to notice that the
flow of water is low when using
the SpaLet
®
seat it may be
time for the filter to be cleaned
out. Especially with new home
construction or newly
renovated plumbing there are
a lot of sediments in the water.
You will need to remove the
connection hose and clean out
the filter as needed.
abrasive cloth or
paper, polishing
agent, fragrance,
insecticide, etc.
1
2
3
4
5
6
7
Filter
Connection
hose
A
B
WARNING
DO NOT OVERTIGHTEN
AS IT WILL DAMAGE
THE CONNECTION.
HAND TIGHTENING IS
RECOMMENDED.
