-16 EN-
1.
Changing emitting signal
(remote control unit)
(1) Remove the batteries from
the remote control unit.
(2) Refer to the signal table
on the right, hold down
the desired button, insert
the batteries and wait for
six seconds with the button
held down.
(3) When the emitting signal
has been changed, the
battery mark on the lower
right of the remote control
unit LCD flashes.
(The number of flashes
differs depending on
the signal that has been
changed.)
2.
Changing receiving signal
(bidet body)
(1) Remove the power plug of
the bidet for which the signal is
to be changed.
(2) Insert the power plug again,
and then press the [STOP]
button at least 10 times within
10 seconds after insertion.
NOTE:
Do not turn on and off
the indoor (equipment) breaker
to perform the above operation.
* If power is turned on
simultaneously for multiple
bidets, the receiving signal of
other bidets may be changed.
* Some signals cannot be set on
some products.
Signal
Number
Operation Button
Battery Mark
No. of Flashes
Signal 1
Water Temp
Once
Signal 2
Seat Temp
Twice
Signal 3
Power save
Three times
Signal 0
Nozzle Cleaning
Four times
Signal 4
Hr
Five times
Signal 5
Min
Six times
Signal 6
Auto clean
Seven times
Signal 7
Dryer temp.
Eight times
* Signal 0 is the default setting.
When multiple bidets are installed, a bidet in other booth may also respond to the signal and malfunction.
To prevent this, you can change the signal using the remote control unit you purchased. Change both the
emitting signal (remote control unit) and receiving signal (bidet body).
When multiple bidets are installed:
