-12 EN-
7
Positioning and Mounting the Remote Control
●
Remote control installation position
Install the remote control to a position where
the user can reach and operate it.
Install the remote control in the area shown as “Suggested installation area”
in the figure below, and ensure to install the remote control on a position
where it can be operated easily while the user is seated on the SpaLet seat.
Unit: mm
(
"
)
900 (35-7/16)
600 (23-5/8)
800
(31-1/2)
1200
(49)
1000
(39-3/8)
Suggested installation area
Suggested installation area
for easier operation
●
Sit on the SpaLet seat and ensure the
installation position. [See Note 7-1]
Temporarily install the remote control to the target position,
and sit on the seat unit and press the [STOP] button
(ensure to perform a test operation after installation).
Then, stand in front of the SpaLet bowl and
push the [STOP] button to ensure that a
beep sound is generated from the seat unit.
• Do not push the [REAR or
[FRONT WASHING] button:
water would come out from the
seat unit.
• Ensure that there is enough space above the remote
control installation position to allow easy removal and
mount of the remote control.
2. Mounting the Remote Control
Installation Procedure
1. Remove the holder from the remote control.
2. Install the holder to the installation
position using an appropriate method
for the wall.
[See Note 7-2]
* Out of 4 slots, use the outer 2 slots (with A marks).
If the holder can be
installed only with a
hole pitch at 100 mm
(3-15/16
"
), use the inner
2 slots.
[For a plywood wall (> 5 mm (3/16
"
) thick)]
Affix the holder firmly with the supplied wood screws.
[For a plywood wall (<5 mm (3/16
"
)
thick) or a plaster board wall]
①
Make the pilot holes with 6 mm (1/4
"
) diameter.
(5 mm [3/16
"
]
diameter for a
plaster board wall)
②
Use a hammer to
insert the supplied
plastic anchors gently.
③
Affix the holder
firmly with the
wood screws.
The wood screws are tight at the beginning,
and then loosened once and tightened again.
[For a concrete wall]
①
Make the pilot
holes with 6 mm
(1/4
"
) diameter
and approx. 33 mm
(1-5/16
"
) depth.
②
Use a hammer to
insert the supplied
plastic anchors
gently.
③
Affix the holder
firmly with the
wood screws.
3. Align the remote
control to the
holder, and push
downward to
mount the remote
control.
4. Press the [Hr] and
[Min] buttons to set
the current time.
* Pay attention to
AM and PM.
100 mm
156 mm
Holder
Wood
screws
Plastic
anchors
Φ 6 mm
(1/4
"
)
Holder
Wood screws
Plastic anchors
33 mm
(1-5/16")
Φ 6 mm
(1/4
"
)
Holder
Wood screws
Holder
Remote
Control
Time setting switch
Hr Min
1. Installing the Batteries and Confirming the Remote Control Installation Position
1. Open the back cover of the remote control, and
install the included batteries (AAA x 2).
[See Note 7-1]
* Use a tool such as a flat-blade screwdriver to push the
hook (lock) to remove the cover.
2. Confirm the remote control installation position.
Batteries
Hook (lock)
Remote control
Back cover
