
13592 Desmond St., Pacoima, CA 91331 818.897.0808 tel 888.753.9898 toll free www.americanrange.com
10
Medallion Dual Fuel Ranges
Use & Care Manual
INSTALLATION INSTRUCTIONS
It is the owner’s responsibility to ensure
that the electrical connection of this
appliance is performed by a qualified
electrician. The electrical installation
must be in accordance with the latest
version of the National Electrical code
ANSI/NFPA 70 and local codes and
ordinances.
Check your local building codes for the
proper method of installation. In the
absence of local codes, this appliance
should be installed in accordance with
the National Fuel Gas Code ANSI Z223.1.
Be certain that the appliance being
installed is correct for the gas service
being provided.
Within the Commonwealth of
Massachusetts, this appliance must be
installed by a licensed plumber or gas
fitter.
Do not attempt to disengage the hinge
catch with the door removed from the
oven. The hinge spring could release
causing personal injury.
Do not lift or carry the oven door by
the door handle.
ELECTRICAL SERVICE
A 240VAC, 60Hz separately grounded circuit that is protected by a 30A circuit
breaker or time delay fuse must be supplied to the appliance.
A four-wire connection (not provided) is required to connect the appliance to the
electrical supply junction box. Consult local building codes for the type and minimum
wire gauge to use. The wiring to the appliance from the electrical supply junction box
needs to be long enough to allow the appliance to be pulled out from the wall for
service, while remaining connected.
GAS SUPPLY
Be certain that the appliance being installed is correct for the gas service being
provided. Refer to the appliance data plate for the gas supply requirements.
Minimum Natural Gas Supply Required – 6" water column
Minimum Liquid Propane (LP) Gas Supply Required – 11" water column
A manual gas shut-off valve must be remotely installed and easily accessible in the
adjacent cabinet.
The regulator inlet is for a 1/2" gas line.
PREPARING FOR INSTALLATION
UNPACKING THE APPLIANCE
Unpack all parts boxes and verify that all of the required components have been
provided. If any items are missing or damaged, please contact your dealer immediately.
Do not install a damaged or incomplete appliance.
REMOVING THE OVEN DOOR
To make the appliance easier to move, remove the door to reduce weight.
1. Open the door to its fully opened position.
2. Place hinge pin in the hole located in hinge arm.
3. Remove left and right hinge locks.
4. Move door upward to engage pin.
5. Lift door out.
CONNECTING THE ELECTRICAL SERVICE
1. Make sure that the conduit or appliance wire is long enough to allow the range
to be pulled out for service without disconnecting it.
2. Connect the wires on the appliance wall electrical box.
CONNECTING THE GAS SUPPLY
1. Make sure the gas supply valve is in the OFF position.
2. Make sure all surface burner knobs are in OFF position.
3. Connect the gas line to the appliance.
4. Connect the gas line to the supply line.
5. Turn on the gas supply and check for leaks.