American Panel Walk-in Monitoring System 200, Руководство пользователя

Страница: 12 / 38

PROGRAMMING
12
4. Change the Access Code
To change the Access Code, you have to enter the programming mode. Follow the instructions below.
Before entering the programming mode, the controller has to be in the “OFF”
state.
If it is not, press and hold for 5 seconds.
The display will show:
To enter the programming mode, press and hold for five seconds.
The display will show:
Enter The Access Code
To enter the default access code, press the following buttons in order: .
When finished, press .
The display will show:
After entering the code successfully, the controller will ask if you want to change
the access code.
To change the code, change the flashing value to “Y” by pressing or
and then press .
Enter The New Code
The display will show:
Enter any three key combination of the following buttons:
.
Next, the controller will display for a second the message shown in the figure on
the right and then switch to the three dashes display.
The display will show:
Re-enter the new code.