Single DIN Mount Applications
1. Attach the left and right side brackets
to the main bracket.
See Figure B opposite page.
2. Insert pocket (part # POC-985)
into lower section of the main frame.
3. Attach left and right side brackets to the rear of the pocket using screws supplied.
4. Insert DIN sleeve from your new radio into the upper section of the installation kit.
5. Depress the tabs from inside the
sleeves opening upward, outward,
and downward to secure sleeve to
the installation kit.
6. Install radio into sleeve
and lock into place.
7. Attach a rear support bracket to the
rear of the new radio and adjust as
necessary to attach to the rear support
stud locate on the back of the pocket
using the small phillips screw
supplied with kit.
8. Attach the vent trim assembly
(removed in step 7 of dash
disassembly above) to the
rear of the installation kit.
Single ISO Mount Applications
1. Attach the left and right side brackets to the main bracket. See Figure B.
2. Insert pocket (part # POC-985) into lower section of the main frame.
3. Attach left and right side brackets to the rear of the pocket using screws supplied.
4. Attach (1) ISO Spacer to the inside of upper section on both Left & Right mounting
brackets as shown in Fig. A. (See note #2 below)
5. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides
of radio using screws provided with radio when possible or hardware included with kit.
6. Slide radio component forward or backward for desired look and tighten screws.
7. Attach the vent trim assembly (removed in step 7 of dash disassembly on page 2)
to the rear of the installation kit.
KIT ASSEMBLY INSTRUCTIONS
2
3
NOTE:
#1 - ISO trim ring (ITR-985) may be used in place of after-market radio’s removable trim ring.
ITR-98
5
(Top)
For ISO mount only:
Attach (1) ISO
Spacer to the inside of upper sections of
the Left & Right mounting brackets as
shown in
Fig. A.
Left
POC-98
5
IMB-985L
IMB-985R
Right
Fig. A
Fig. B
Main
Frame
NOTE:
ISO trim ring (ITR-985) may be used in
place of after-market radio’s removable trim ring.
KIT ASSEMBLY INSTRUCTIONS
1. Carefully unclip and remove the trim panel that stretches from above the glove box
to below the Climate Control module.
2. Unscrew and remove the Shifter knob.
3. Carefully unclip and remove the shifter trim panel.
4. Unclip the Climate Control module, and rest out of the way.
5. Remove the (4) 10 MM bolts securing the radio to the sub-dash.
6. Carefully pull the Radio/Vent assembly forward, disconnect all attached harnesses
and antenna lead and remove Radio/Vent assembly.
7. Remove the (4) Phillips screws securing the Vent trim assembly to the radio and set
aside the trim to be attached to the installation kit.
1. Remove the factory radio (upper side)
mounting brackets, as shown in
Fig. D below, and attach to the rear side
of the TOY-K985 main bezel using the
screws from the factory radio.
DASH DISASSEMBLY AND RADIO REMOVAL INSTRUCTIONS
2011 TOYOTA SIENNA
Main F
rame
DIN Sle
eve
Fig. D
