Double DIN & Double ISO Mount Applications
1. Remove the shaded tab from the bottom of each left and right mounting bracket. See fig. C illustration below.
2. Attach the left and right side brackets to the main frame. See figure C below.
3. Cut and remove the center rib from the main frame and file edges smooth.
4. Follow steps 4-6 from single ISO instructions on page 3. (See note #2 below)
5. Attach a rear support bracket to the rear of the radio components and adjust as needed
to allow rear support bracket to rest in the sub-dash.
6. Attach the vent trim assembly (removed in step 7 of dash disassembly on page 2)
to the rear of the installation kit.
CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
Toyota
2011-12 SIENNA
VEHICLE APPLICATIONS
KIT ASSEMBLY INSTRUCTIONS
NOTE:
#1 - ISO trim ring (DITR-985) must be used in place of after-market radio’s trim rings. For ISO mount
applications, mount after-market radio components to side brackets using screws provided with
radio when possible or hardware included with kit.
For ISO mount only:
Attach (1) ISO Spacer to the
inside of upper sections of the Left & Right
mounting brackets as shown in
Fig. A.
Cut
Cut
Left
Right
Fig. A
DITR-9
85
IMB-985L
IMB-985R
Fig. C
Main Fra
me
TO
Y-
K9
85
M
o
u
n
ti
n
g
K
it
iTOYK985
REMOVE SHADED
POCKET SUPPORT TABS
(Both L&R mounting brackets)
©2012 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 6/12 PRINT Ver. 5/11
