Interrupters User Guide
Chapter 5: Interrupter Programming
38
Figure 5-2. UTC Offset Screen
3.
Press
or
to scroll through the UTC offset values.
4.
Press
ENTER
to set the UTC value and return to Options menu.
Using Zero Crossing
The MicroMax interrupters usually use a GPS reading to take timed measurements. Zero Crossing
allows you to use the instant when the AC crosses zero instead of using a GPS reading.
Complete the following steps to enable or disable Zero Crossing:
1.
From the main menu, press
4
on the keypad to display the Options menu.
Figure 5-1. Options Menu
2.
Press
7
to display the Zero Crossing Switching screen:
Figure 5-2. Zero Crossing Switching Screen
3.
Press
to change the status of Zero Crossing from
Enabled
to
Disabled
or from
Disable
to
Enabled
.
4.
Press
ENTER
to return to the Options menu
.
Resetting to Factory Defaults with Keypad
Complete the following steps to reset the interrupter with factory default settings using the unit's
keypad. Refer to
Factory Defaults Settings on page 56
for a list of the factory default settings. The unit
can also be reset to factory defaults by using tBullhorn Tools software. Refer to
Defaults with Keypad on page 38
for more information.
Содержание MicroMax GPS360
Страница 1: ...Proven compliance solutions Relentless service Interrupters User Guide Interrupters User Guide...
Страница 5: ...Interrupters User Guide v Appendix E Regulatory Notices 63 Export Control Classification Number 63...
Страница 60: ...Interrupters User Guide Chapter 5 Interrupter Programming 55 The configuration is now complete...
