American Hometec AHQ-B03X, Инструкция по установке и эксплуатации

Страница: 11 / 59

11
6. Adjust the desired water temperature by pressing power level “UP” or
“DOWN”
on the control panel. Increasing the power level will increase
the water temperature. Decreasing the power setting will result in
cooler water. Note: incoming water supply temperature may change
seasonally. For optimal energy savings, an adjustment may be required in
the winter or in the summer. The power setting can be adjusted as
follows:
Power Adjustment Range
Power setting selection (Fig 5) Setting 1 Setting 2
Power setting 3.4 kW 2.4 kW
Adjustment range (power
levels)
Low: 1
-
High: 4 Low: 1
-
High: 3
7. Register the unit for warranty purposes at www.americanhometec.com
Operation
Power indicator light
Power level indicator lights. 4 lights are available
for power level 1 to 4 when unit is installed at
3.4kw. 3 lights are available for power level 1 to 3
when installed at 2.4kw.
UP and DOWN buttons for adjusting power levels
ON/OFF POWER button for turning heater on or off.
When heater is
powered on, unit is on standby until
there is a hot water demand. Unit will heat water
whenever hot water faucet is turned on and
incoming water temperature is lower than 125
o
F. If
the heater will not be in use for a long time (such as
during vacation), this POWER button is recommended
to be
turned off. Pressing ON/OFF button for 5
seconds, if 3 lights blinking for 3 times, it is set to
2.4kw. If 4 lights blinking for 3 times, it is set to
3.4kw. Wire accordingly for installation.