Step 10: Start by taking the two long rail/blind assemblies and position by lining up the rail bolt holes in
the slate and the cooresponding threaded rods of the rail. Hand tighten the rails using the domed
washer and nut. (Dome of washer faces down)
Step 11: Using the same process as the previous step, do the same with the end rail/blinds assemblies.
Be sure to carefully align the corners of the table so there is no gap between the side and end aprons.
Step 12: For this step be sure to set Power Drill on low torque or power setting. Carefully secure the rail
blind corners using the provided 1” Corner Cleat Screws on the interior of the blinds. Now tighten all rail
nuts with deep well socket.
