Page 3
INS_Remote Control - Gray
REMOTE CONTROL OPERATION
E. MATCHING SECURITY CODES
Before matching security codes make sure 120V AC is connected and powered to fi replace, and hand held remote control is installed with (2)
batteries.
It may be necessary to program main control module to LEARN the security code of the hand held remote control upon initial use, if batteries are
replaced, or if a replacement remote control is purchased from your dealer.
1.
When matching security codes, be sure slide button on main
control module is in REMOTE; the code will not “LEARN” if slide
is in OFF.
2.
Program main control module to LEARN a new security code by
pushing in LEARN button on main control module using a pencil
point for 2 seconds and let go (you should hear a series of ‘beeps’
letting you know module is ready to learn a new code).
3.
Immediately press MODE button on hand held remote control
(you should hear four ‘beeps’ in rapid succession in main control
module, indicating remote
control’s code has been programmed into the main control
module). When an existing main control module is introduced
to a new hand held remote control, the new security code will
overwrite the old one.
If it ever becomes necessary to clear the memory from the hand held
remote control, simply push and hold the LEARN button for 10 seconds
(you should hear three long beeps in succession). You may now follow
steps outlined above to ‘RE-LEARN’ security codes.
Figure E
LEARN BUTTON
PILOT IGNITOR
CONNECTION
PILOT SENSOR
CONNECTION
REMOTE
ON/OFF SWITCH
CONTINUOUS
PILOT SWITCH
120 VAC
ADAPTER
CONNECTION
WIRE HARNESS CONNECTION
TO EXTENSION MODULE
WIRE HARNESS CONNECTION
TO VALVE STEPPER MOTOR
▲
▲
▲
▲
▲
▲
▲
▲
Slide To REMOTE
F. INTITAL SET-UP
Plug Extension Module and AC Adaptor into receptacles.
The
Hand Held Remote
operates on (2) AAA batteries. We recommend always using ALKALINE batteries to extend battery life and improve
operational performance.
This system allows for gas type conversion and temperature unit conversion by following the setup procedure outlined below.
G. GAS TYPE CONVERSION
Press and hold
Learn
Button on Main Control Module for 20 seconds. A beep will be heard letting you know the procedure has been completed.
•
If converting from NAT to LP gas: (1) one second long beep
•
If converting from LP to Nat gas: (3) three second long beep
Continue with gas type conversion by following instructions included with gas conversion kit.
NOTE: This system is sent to you set up for Natural Gas and temperature units readable in Fahrenheit.
f i r e - p a r t s . c o m
