American Eagle 53887, Руководство пользователя

Страница: 14 / 34

10 SRS-65 Owner’s Manual
The separator cartridge is disposable and is located on top of the filter support.
The cartridge has to be replaced at least once per year and at a maximum of 3000 operating hours. If
intake air is often contaminated or the oil quality is poor, the cartridge will tend to clog earlier and will need
to be changed more often.
Maintenance Procedure:
1. Turn off the compressor, hydraulic system and truck engine to ensure
that compressor is not started.
2. Slowly unscrew and remove cartridge with an oil filter wrench.
3. Screw the new cartridge onto the filter support. Hand tighten, do not
use a filter wrench. Turn approximately 3/4 turn after gasket contacts
the compressor.
4 Write the date of change and operating hours on cartridge.
5. Run compressor for 3 minutes.
6. Check cartridge to ensure that it is tight.
Intake Filter
The air intake filter should be changed every 100 hours of operation. The filter may require changing or
cleaning more frequently if the compressor is operated in a dusty environment.
Maintenance Procedure:
1. Turn off the compressor, hydraulic system and truck
engine to ensure that compressor is not started.
2. Open filter lid and carefully remove filter.
3. Carefully remove dust from the intake housing.
4. Clean and install or install new filter.
•Clean filter be tapping outside of filter on a hard
surface.
•Clean filter with compressed air by blowing from the
inside to the outside. Limit air pressure to 75 psi.
5. Close filter lid.
6. Test run compressor.
ATTENTION: ANY DIRT OR DEBRIS THAT ENTERS THE
COMPRESSOR INTAKE WHEN THE AIR FILTER IS REMOVED
CAN CAUSE IRREVERSIBLE DAMAGE.
Separator Cartridge
The oil filter is located to the front of the unit. When viewing the unit from the oil fill cap end, the oil filter will
be to the left front. It is necessary to remove the side panel to access the oil filter. Replace the filter after the
first 50 hours of service and every 1,000 hours thereafter.
Maintenance Procedure
1. Turn off the compressor, hydraulic system and truck engine to ensure
that compressor is not started.
2. Slowly unscrew and remove the oil filter with an oil filter wrench.
3. Grease the new filter gasket.
4. Before installing, hold the new filter upright and fill it with the same oil as
used in the compressor case.
5. Screw the new filter onto the compressor. Hand tighten, do not use a
filter wrench. Turn approximately 3/4 turn after gasket contacts the
compressor.
6. Run compressor for 3 minutes.
7. Check oil level and fill if necessary.
Oil Filter
OIL FILTER
P/N 15323
SEPARATOR
CARTRIDGE
P/N 15324
AIR FILTER
P/N 15322