American Dynamics SpeedDome LT, Инструкция по установке и обслуживанию

Страница: 23 / 41

INDOOR INSTALLATION
SPEEDDOME LT
2-8
Chassis Installation
This procedure explains how to mount the chassis
within the dome housing.
Install Kit Supplied
0351-0558-01*
a) Connector, BNC, Plug, RG59 1 2111-0035-01
b) Connector, BNC, Jack, RG59 1 2111-0034-01
c) Cable Tie, Nylon, 4” 3 6009-0006
d) Tubing, Heat Shrink, Black .8ft 3121-0007
e) Resistor, 180-ohms, ±5%, .25W 2 4711-1800-700
f) Tubing, Heat Shrink, Black .5ft 3121-0027-01
* Alphabetical parts listing does not correspond to parts used in
this procedure.
Procedure
1. Snap the ball (a) of the lanyard hanging from
the chassis into the bracket (b) at the top of
the housing (Figure Chapter 2-10).
2. Place the chassis in the housing.
Squeeze the spring-loaded ejector pins (c) together
to seat the chassis in the corner receptacles (d). The
PC board must face the cables exiting the access
holes in the housing.
Note: After the chassis is in place, remove the foam
packing that prevents the eyeball assembly from
pivoting during shipment.
Figure Chapter 2-10. Chassis installation
3. If using a patch cable (0650-0657-01),
connect the cable ends to their respective
receptacles on the Unicard and on the
composite cable from the J-Box (Figure
Chapter 2-11).
Note: If you must replace the Cinch-Jones connector
on the existing composite cable from the J-Box with
a female compression-type connector, continue to
step 4.
Note: If using customer-supplied 22 AWG cable,
wire the receptacle style, compression-type, P3
connector, which comes with the dome, in
accordance with the “Connector Pin Out” table
(column P1) on the next page.
With the chassis hanging down, connect the video
and multiconductor cables to their receptacles (e).
Note: Do not use the alarm input connector (f).
e
d
c
g
a
b
f
h