8000-2692-01, Rev. E
Page 2 of 18
5
S
S
6
7
Secure the housing to
a strong structural
ceiling member.
Secure the housing to
the ceiling.
Attach the bubble
to the housing.
Place the large hole in the
end of the lanyard over the
screw head on the bubble.
Pull the end of the lanyard to
the inside of the bubble to
snap it in place.
Align tabs in the
bubble with mating
tabs in the housing.
Turn the bubble clockwise
until it catches the tabs and
stops.
Insert housing.
Turn each of the four
locking screws clockwise
to seat the “swing out”
mounting clips tightly
against the ceiling.
Attach an S-hook to
safety chain supplied,
then attach the S-hook
to the housing. Close
the ends of the S-hook.
Attach the end of the
chain to itself using
another S-hook. Close
the ends of the S-hook.
Run the chain up into
the ceiling and wrap it
around a structural
member above the
housing.
Keep the chain taught
as possible. Do not
secure the housing to
a fire control system.
A
A
A
B
B
B
C
C
C
Green, red, and yellow LEDs will light in
various patterns to indicate status.
Typically, these LEDs do not need to be
viewed unless a failure occurs. See
“Troubleshooting” in information
attached for an explanation
Of the LED patterns.
Power the dome (heater fans turn on).
The camera lens then follows a pattern
until it reaches its home position. The
controller can then be used to call up
and control the dome.
If OK, continue. If not, see
“Troubleshooting” in information
attached.
