SPEEDDOME ULTRA INDOOR HOUSING AND INDOOR VANDAL-RESISTANT HOUSING
8200-0184-07, REV. B
INSTALLATION GUIDE
3 of 4
Installation
WARNING:
Ensure that ac power and
electrical signals are off before beginning
this procedure.
1. See instructions supplied with the SpeedDome
Ultra housing and eyeball assembly for how to
prepare it for installation in the housing.
2. Connect the housing and eyeball assembly to
the base (Figure 2) by aligning the Cap and
Base tabs and then turning clockwise until you
hear a click.
Figure 2. Attaching dome to the base in an
indoor housing (cables and lanyard
not shown)
Referring to Figure 3:
3. Remove the bubble assembly from the package
and ensure the bubble is clean and free of
debris.
4. Attach the coiled lanyard from the bubble to the
threaded stud on the indoor housing using the
thumbnut supplied.
5. Attach trim bubble assembly.
a. Discard the red “CAUTION: Remove slot
covers” tag. There is no need to remove the
slot covers for indoor applications.
b. Align the key on the inside of the bubble
assembly with the detent on the edge of the
housing.
CAUTION:
To maintain the integrity of the
gasket seal between the housing flange and
the trim ring, do not let the lanyard get
caught between these two pieces as you
secure the bubble assembly to the housing.
c. Use the drive (taped inside bubble) to
tighten the four tamper-proof screws on the
bubble assembly. To compress the gasket
evenly, tighten each screw in clockwise
formation until slight resistance is felt, then
retighten each screw again in clockwise
formation until all screws are evenly tight.
6. See instructions for the mounting structure for
how to attach the housing assembly.
Figure 3. Attaching bubble assembly
Sun Shield
Detent
Key
(inside
bubble
assy.)
Lanyard
Stud
!
Align tabs on
Cap and Base.
Turn clockwise
to latch
