SPEEDDOME ULTRA INDOOR HOUSING AND INDOOR VANDAL-RESISTANT HOUSING
8200-0184-07, REV. B
INSTALLATION GUIDE
2 of 4
Warnings and Cautions
Please review the following warnings and cautions
before you begin installation or service.
WARNINGS
WARNING!
ALWAYS USE:
•
Proper safety equipment for the
location and type of installation.
•
Proper lift equipment to reach the
installation.
•
Safety features of the lift equipment.
BE SURE:
•
Electrical power is not connected to
the dome when connecting wires.
Dome will move when power is
applied.
•
Electrical power is not connected to
nearby fixtures that you might touch
during installation.
WARNING!
The camera dome used in this
housing runs on 24Vac.
DO NOT
connect line voltage to this dome.
Worldwide power requirements:
A
certified limited power source is required.
North America power requirements:
This device is intended to be supplied
from a Class 2 power supply.
This installation should be made by a
qualified service person and should
conform to all local codes.
WARNING!
DO NOT install this housing in
hazardous areas where highly
combustible or explosive products are
stored or used.
CAUTION
There are two boxes: one for the indoor housing,
and one for the bubble assembly. Protect the
bubble assembly by leaving it in its box until you
are ready to install it.
Equipment Required for
Installation
Parts Supplied
- Standard housing assembly 0201-0007-01
- Vandal housing assembly 0201-0007-02
- Standard bubble assembly 0400-1402-01/-02
- Vandal bubble assembly 0404-0083-01/-02
- Tamperproof
drive
1400-0149-01
(supplied with bubble)
Purchase or Supply Separately
- RUIOB Indoor I/O Board or
RUPTB Pigtail Board
Tools Required
- 6mm (.25in) fixed-handle nut driver for Torx bit
- Small screwdriver for tightening connectors
- Wire cutters and strippers
