Quick Setup Guide
2. Flank Panel
-- Left Flank Panel --
-- Right Flank Panel --
1
2
3
4
5
6
7
1. Lens
Mount:
This IP camera is used with either a C or a CS mount lens.
2. DIP
Switch:
1. AES:
Auto electric shutter.
2. DC IRIS:
Use an auto iris (DC drive)
3. DHCP:
Turn On / Turn Off to use the DHCP protocol. If the switch points upwards, the
device can change the setup of network function (enable/disable) via the network.
4. STATIC IP:
If the switch points down, the device can’t obtain an IP address from the DHCP
server. This option is needed to configure the network communication settings.
(*In the default factory configuration, this DIP Switch is in the Down position.)
3. ALARM
I/O:
This is a 6-PIN connector including the
ALARM IN/OUT, ALARM RESET
and
GROUND
items
for connecting with external devices.
RS485 pin: D+
RS485 pin: D-
GND:
Ground Contact.
ALARM IN (INPUT):
This is an alarm input which can be programmed in the menu system to
Normally Open or Normally Closed. ( )
ALARM OUT (OUTPUT):
This is an alarm-output trigger. Connect this to external devices such as
buzzers or lights. ( )
ALARM RST (RESET):
This pin connects to an alarm-clear device for clearing an alarm.
( )
5V
0V(Active)
5V
0V(Active)
5V
0V(Active)
4. RESET:
Recover to factory default.
5. 5pin MINI USB Port:
The user can
use a USB device cable to connect the IP camera to the USB port
on the PC
.
6. ALC
VR:
Iris control VR.
When an auto iris (DC Drive) lens is used, this VR is used to adjust the iris for different lighting
environments. Adjust the VR clock-wise to open the iris and counter-clockwise to close the iris of the
camera.
7. IRIS:
Auto iris connector.
This camera works with a DC drive auto iris lens. Please refer to the pin assignment marked on the
camera when connecting the auto iris lens.
5
