American Dynamics AD2089, Руководство оператора

Страница: 16 / 60

Connection and Setup of the AD2089
8 AD2089 Operator’s Manual
2 To change the currently displayed volume level, cycle through the levels using the NEXT or
LAST keys to move in forward or reverse direction respectively. Each time the level changes, a
short tone sounds indicating the new level.
3 When the appropriate level appears in the ENTER display, press the PROG key to save the
selection. You now have the option to either set the PTZ motion control option using the
following procedure, or exit the setup mode by pressing the F1 key, turning the keyswitch to
OPERATE, MENU, and then back to OPERATE again.
To Set the Pan / Tilt / Zoom Motion Control Option
Depending on the particular switching system that is used with the AD2089 keyboard, the pan, tilt,
and zoom (PTZ) motions of the system cameras are controlled by one of two methods:
Repeat or
Make/Break . Detailed descriptions of these two methods are beyond the scope of this manual, but
a system administrator will be advised of the appropriate method to use, and will make the
appropriate setting accordingly.
1 After speaker volume level selection has been completed, the letters "rpt =" appear in the
CAMERA display. "AUTO" will appear in the ENTER display. “AUTO” indicates that the
switching system being used will automatically select either the Repeat or Make/Break control
method.
2 You can step through the “AUTO”, "OFF" and "ON" states by using the NEXT or LAST keys. If
"OFF" is displayed, the
Repeat method will be set off . If "ON" is displayed the Repeat method
will be set on. The AD168 system operates with Repeat set to OFF. American Dynamics
systems that operate with Repeat set to ON include AD1650B, AD1024, AD2052, AD2150, and
AD2350. Consult with your system administrator about the appropriate setting for your system.
3 When the appropriate state appears in the ENTER display, press the PROG key to save the
selection. You now have the option to either set the baud rate using the procedure indicated on
page 2-3, or exit the setup mode by pressing the F1 key, turning the keyswitch to OPERATE,
MENU, and then back to OPERATE again.
Resetting Keyboard Parameters
1 To reset baud rate, LED brightness level, speaker volume level, and the PTZ motion control
option to factory default settings, first unplug the keyboard's wall transformer.
2 Press and hold the F1 and PROG keys simultaneously while plugging the transformer back in.