Mounting (Continued from page 2)
ATTACHING SIDE MOUNT PLATFORM TO AD1240
MAIN BODY
The Side Mount Platform has several sets of mounting holes
for attachment to the AD1240, as shown in Figure 4, page 5.
These enable adjustment between the center of gravity of the
camera and the center line of the AD1240 tilt shaft. Refer to
the Dimensions drawings on the inside rear cover for the
location and dimensions of these mounting holes.
Note: For inverted mounting, invert the position of the Side
Mount Platform (see Figure 3, page 3).
Secure the Side Mount Platform to the AD1240 Main Body
using four 4 mm cap head screws and lock washers (see
Figure 4, page 5).
ATTACHING CAMERA HOUSING TO SIDE MOUNT
PLATFORM
The Side Mount Platform has several holes and slots at
various positions on the bottom plate for mounting most
types of camera housings. Refer to the Dimensions
drawings on the inside rear cover for the location and
dimensions of these mounting holes.
Mount the camera housing so that the camera is on the right
side of the AD1240 as seen looking into the front (lens) of
the camera (see Figure 5, page 5). The front of the AD1240
is the surface opposite to the connector.
Note: For inverted mounting, the camera is on the left side
of the AD1240 (see Figure 3, page 3).
Secure the camera housing to the base of the Side Mount
Platform using 6 mm cap head screws. Refer to the
appropriate camera housing Installation Instructions for
specific mounting instructions.
4
MOUNTING
AD1240
