©
American DJ Supply
®
- www.americandj.com - Warp Tri LED™ Instruction Manual Page 5
Warp Tri LED™
Cleaning
Warp Tri LED™ Fuse Replacement
©
American DJ Supply
®
- www.americandj.com - Warp Tri LED™ Instruction Manual Page 6
Warp Tri LED™
Trouble Shooting
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses should be carried out periodically to optimize light
output. Cleaning frequency depends on the environment in which the
fixture operates (I.e. smoke, fog residue, dust, dew). In heavy club
use we recommend cleaning on a monthly basis. Periodic cleaning
will ensure longevity, and crisp output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Clean the external optics with glass cleaner and a soft cloth every
20 days.
3. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
4. Always be sure to dry all parts completely before plugging the unit
back in.
Trouble Shooting:
Listed below are a few common problems that you may encounter,
with solutions.
No light output from the unit;
1. Be sure you have connected your unit into a matching wall power
outlet.
2. Be sure the breaker has not popped. The breaker is located on
the rear panel.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
Warp Tri LED™
Operation
Switch in the “II” sound active position: Mode 3 - In the this mode the
gobo wheel will react to sound. Please note that tapping on the unit,
or high pitched sounds may not trigger the unit, the unit is designed
to react to low frequencies (bass). Also note that the music sensitivity
is preset at the factory and may not be changed or adjusted.
Fuse Replacement:
First unplug the power. The fuse holder is lo-
cated at the rear of the unit next to the power cord. Using a flat-head
screw driver unscrew the fuse holder. Remove the bad fuse and re-
place with a new one.
