American DJ
®
- www.americandj.com - Vizi LED Spot - Instruction Manual - Page 45
American DJ
®
- www.americandj.com - Vizi LED Spot - Instruction Manual - Page 46
Vizi LED Spot
Changing the Gobo
Vizi LED Spot
Changing the Gobo
This unit comes with interchangable gobos. When changing
the gobos please be very careful. Follow the instructions below,
and see the figure pictures on the next page.
Caution!
Never open the unit when in use. Always disconnect
the main power before attempting to change the gobos.
1. To change the gobo, you must remove the bottom half of the
moving head. The bottom half of the moving head does not
have the lens in front. The lens is on the top half of the head
(Figure 1).
2. Unscrew the 4 phillips screws that secure the bottom half
shell. Remove the bottom half of the shell.
3. When you remove the shell you will be able to access the
gobo wheel. Turn the wheel with your hand until you come
across the gobo you would like to change (Figure 2).
4. You have to remove the individual gobo set-up. Gently push
the gobo frame (Not the wheel) away from the gobo wheel,
you do not have to push gobo frame to far (Figure 3). While
you are pushing the gobo frame away from the wheel, pull
the gobo frame up and out (Figure 4).
5. Once the gobo frame has been removed, remove the fixture-
ring and gobo. This can be done by gently pushing the gobo
out towards the back. When doing this you do not need a lot
of pressure. The fixture-ring and gobo should easily come
out of the frame.
6. Change the gobo, replace the fixture-ring. When inserting
the gobo frame back into the unit, the bottom of the gobo
frame must slide underneath the metal place holder located
at the bottom of the gobo wheel (Figure 5).
7. Reassemble the unit.
Figure 1
Figure 2
Figure 3
Figure 5
Figure 4