background image

  Quad Scan LED    

 

                             Cleaning

  Quad Scan LED    

 

                Trouble Shooting

Trouble Shooting: Listed below are a few common problems that 

you may encounter, with solutions.
No light output from the unit;
1.   Be sure the external fuse has not blown. The fuse is located on  

   the rear panel of the unit. 

2.   Be sure the fuse holder is completely and properly seated. 

 

Unit does not respond to sound;
1.     Low frequencies (bass) should cause the unit to react to sound.

    Tapping on the microphone, quiet or high pitched sounds may

   not activate the unit.  

Fixture  Cleaning:

 Due to fog residue, smoke, and dust cleaning 

the internal and external optical lenses and mirror should be carried 

out periodically to optimize light output. Cleaning frequency depends 

on  the  environment  in  which  the  fixture  operates  (I.e.  smoke,  fog 

residue, dust, dew). In heavy club use we recommend cleaning on a 

monthly basis. Periodic cleaning will ensure longevity, and crisp out-

put.
1.  Use normal glass cleaner and a soft cloth to wipe down the out- 

  side casing.

2.   Use a brush to wipe down the cooling vents and fan grill.

3.   Clean the external optics and mirror with glass cleaner and a soft  

  cloth every 20 days.

4.   Clean the internal optics with glass cleaner and a soft cloth every  

  30-60 days.

5.  Always be sure to dry all parts completely before plugging the unit  

  back in.

  Quad Scan LED 

                                           Fuse Replacement

American DJ

®

  -  www.americandj.com  - Quad Scan LED Instruction Manual Page 22

American DJ

®

  -  www.americandj.com  - Quad Scan LED Instruction Manual Page 21

 Quad Scan LED                   28 Channel Mode - DMX Traits

  

Channel    Value 

 

        Function

        

       26                                              BLUE (MIRROR 3)

                        0 - 255                         0% - 100%

       27                                  MASTER DIMMER (MIRROR 4) 

                        0 - 255                         0% - 100%

       28                                       STROBING (MIRROR 3)

                        0 - 8                                  OPEN

                        9 - 131             STROBING SLOW - FAST

                    132 - 139                              OPEN

                    140 - 181           FAST CLOSE - SLOW OPEN

                    182 - 189                              OPEN

                    190 - 231           SLOW CLOSE - FAST OPEN

                    232 - 239                              OPEN

                    240 - 247            SOUND ACTIVE STROBING

                    248 - 255                              OPEN

Disconnect the unit from its power source. Remove the power cord 

from the unit. Once the cord has been removed, you will find that 

the fuse holder is located inside the power socket. Insert a flat-head 

screw driver into the power socket and gently pry out the fuse holder. 

Remove the bad fuse and replace with a new one. The fuse holder also 

has a holder for a spare fuse.

  Quad Scan LED 

                                           Fuse Replacement

The Quad Scan LED comes with 4 replaceable gobos. This gobos 

can be interchanged at any time and allows you to customize your 

system. 
To replace gobo;

1. Select the gobo you would like to replace and unscrew the thumb  

    screw that is holding the gobo housing in place. Note: The thumb  

    screw cannot be removed.

2. Remove the gobo housing.

3. Once the gobo housing has been removed, remove the retaining

    ring that holds the gobo in. This can easily be done using needle  

    nose pliers.

4. Remove and replace the gobo with your desired replacement.       

    Reinsert the retainer ring, and make sure the ring rests firmly    

    against the gobo.

5. Slide the gobo houseing back into place, and secure the housing  

    by tighting the thumb screw. 

Содержание Quad Scan LED













Отзывы: