©
American DJ
®
- www.americandj.com - Micro Galaxian Instruction Manual Page 9
©
American DJ
®
- www.americandj.com - Micro Galaxian Instruction Manual Page 10
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning
the internal and external lenses should be carried out periodically to
optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Clean the external optics with glass cleaner and a soft cloth every
20 days.
3. Always be sure to dry all parts completely before plugging the
unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy use we recom-
mend cleaning on a monthly basis. Periodic cleaning will ensure lon-
gevity, and crisp beam output.
Micro Galaxian
Cleaning
Micro Galaxian
Trouble Shooting
Trouble Shooting: Listed below are a few common problems that
you may encounter, with solutions.
No laser output from the unit;
1. Be sure you have connected your unit into a standard wall
outlet.
2. Be sure that the unit is not in blackout mode.
3. In cold temperature situations it might take the laser a little longer
to produce output. It can take up to 3-5 minutes for the laser to
produce a beam. This is due to the laser diode which is very sen-
sitive.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
Micro Galaxian
Laser Remote Reset
Follow these simple instructions to reset your remote code.
1 2
Erase Remote Code:
Using a small pointy utensil, carefully press and hold the white
button (2), while doing this the indicator light (1) will glow for about 5
seconds then turn off. Once the indicator light turns off release the
button (2).
Activating and Linking Remote:
This action will set the code to link the laser to your remote. You can
link more then one laser to a remote.
Using a small pointy untensil, carefully press the white button (2)
and then press any button on the remote control. After pressing the
button on the remote control the indicator light (1) will flash 4 times.
Try to control the unit with the remote. If the unit can be controlled,
setting the code was successful. If it does not control the unit, try
agin.
